Can I use Fluo-200 fluorometer to test reagents from other manufacturers?

Author: vch12331545

Published on: 2022-06-06 21:19

Classification: Common problem

Yes, the kit used on the Fluo-200 is open. Most manufacturers' kits can be directly tested by calibrating only two standard sample points. If you are worried about the error of the kit, you can also rebuild the standard curve by preparing multiple standard sample points.

Recommended Articles

Can Feyond-A300 perform flash double luciferase detection?

2022-06-06

Yes, Feyond-A300 can be configured with a fully automatic sampler to adapt to the detection of flash type luminous reagents.
Can Feyond-A300 perform spectral scanning on fluorescence?

2022-06-06

No, the fluorescence function of Feyond-A300 uses the filter mode for wavelength selection, and spectral scanning cannot be performed. If the wavelength required for the experiment is not within the bandwidth of the standard filter, the required filter needs to be customized.
Can Fluo-200 fluorometer judge the purity of the sample?

2022-06-06

No, the fluorometer needs to be equipped with a fluorescence kit, which can only give the concentration of the sample. Because it is not measured by absorbance, it cannot give the purity judgment of A260/A280. If purity data is required, micro spectrophotometer can be used for testing.
If a micro spectrophotometer is used, can a sample be measured many times?

2022-06-06

When the sample is placed on the base for a long time, evaporation may occur, and bubbles may be introduced during a test, resulting in inaccurate measurement. Therefore, we recommend that the sample be loaded again each time.